Left Sided Right Angle 14ft x 20ft x 24ft5in - Sunbrella Terracotta -Triangle Shade Sail
(Click to Enlarge)

Left Sided Right Angle 14ft x 20ft x 24ft5in - Sunbrella Terracotta -Triangle Shade Sail

Left Sided Right Angle 14' x 20' x 24'5" Terracotta



Sunbrella Right Angled Triangle Shade Sails feature Sunbrella breathable fabric to keep you cooler and more comfortable in hot weather. These sails can be mounted to a variety of surfaces and are easy to install. Use a shade sail to create a shaded area anywhere around your home or office. This state of the art material is unaffected by moisture and natural temperature extremes. Sunbrella fabric is fade and water resistant. The near waterproof fabric also resists stains, mildew and rot. The perimeter of each sail is contains seatbelt type webbing for increased strength & durability. Each corner has a welded solid marine grade, stainless steel attachment ring to aid in attaching to a structurally sound fixing point. Shade sails, when installed properly, do not sag or flap in the wind.

All measurements are approximate and state the distance from the tip of one D-ring to the tip of the next D-ring along each side in a straight line assuming correctly installed and proper tension has been applied.

Sunbrella Shade Sails need to be installed with a slope of at least 18 to 20 degrees to allow proper water to run off to prevent water pooling on top of the sail. Due to the limited available Sunbrella fabric widths, there will be seams approximately every 40-57 inches.

Note: Recommended attachment points should be at least 10% longer than the side of the shade sail to allow for attachment hardware and to allow for proper tensioning. IE: If the distance of the side of the shade sail is 10 feet, then the attachment points for this side of the shade sail should be at least 11 feet apart.

Custom sizes are available.

Features of Left Sided Rt Agl 14ftx20ftx24ft5in Terracotta
  • Side A = 14' (168 inches)
  • Side B = 24'5" (293 inches)
  • Side C = 20' (240 inches)
  • Made of SunBrella Marine Grade Awning Fabric.
  • Stainless Steel D rings in each corner.
  • 1.5 inch Heavy Duty Webbing sewn into Perimeter ~ 1000lbs / linear foot.
  • Near Water Resistant.



  • This item has been discontinued. We apologize for any inconvenience.

    Last Updated: 02/16/2024 12:01 PM - ID:1769